Re: Не работают исходящие звонки с интертелекома. Freepbx 12
Добавлено: 07 окт 2015, 16:36
Для кого я блок схему рисовал-паблишил?
Русский форум Asterisk сообщества
https://forum.asterisk.ru/
Из описалова кода 21:Executing [s@macro-dialout-trunk:23] NoOp("SIP/314-00000089", "Dial failed for some reason with DIALSTATUS = CHANUNAVAIL and HANGUPCAUSE = 21") in new stack
Двояко. Или Asterisk 11 всегда так пишет при Forbidden?Code No. 21 - call rejected.
This cause indicates that the equipment sending this cause does not wish to accept this call. although it could have accepted the call because the equipment sending this cause is neither busy nor incompatible. This cause may also be generated by the network, indicating that the call was cleared due to a supplementary service constraint. The diagnostic field may contain additional information about the supplementary service and reason for rejection.
What it means:
This is usually a telco issue. The call never reaches the final destination, which can be caused by a bad switch translation, or a misconfiguration on the equipment being called.
Смотрим ещё раз на шаг №2 в блок-схеме?Zavr2008 писал(а):ded, именно. там красным с самого верха шаг 2..